HDT/6/24-F1,1
Article number: 56 101- Combined two-stage surge protectors intended for a low voltage data and power supply lines routed by a common cable.
- Contains both 1st and 2nd stage of protection.
- The overcurrent protection of the power supply line is ensured by a PPTC resettable fuse.
- To reset the PPTC, the circuit must be switched off and let the fuse cool down, do not have to be changed.
- The protection devices must be installed just in front of the protected device.
pcs
Inquire
Testing category according to IEC 61643-21:2000 and EN 61643-21:2001 | C1, C2, C3 | |
Connector type | Screw terminals | |
Rated operating DC voltage (Data line protection) | UN | 0 ÷ 6 V |
Maximum continuous operating voltage DC (Data line protection) | UC | 7.2 V |
Rated load current (Data line protection) | IL | 0.1 A |
Rated operating DC voltage (Power supply system protection) | UN | 0 ÷ 24 V |
Maximum continuous operating voltage DC (Power supply system protection) | UC | 28.6 V |
Rated load current (Power supply system protection) | IL | 1.1 A |
Hold-current of the resettable fuse at -40, 23, 70 °C | Ihold | 1790, 1100, 580 mA |
Trip-current of the resettable fuse at -40, 23, 70 °C | Itrip | 3580, 2200, 1160 mA |
C1 Nominal discharge current (8/20) | In | 1 kA |
C1 Voltage protection level at In (line/G) | Up | < 40 V |
C1 Voltage protection level at In (line/line) | Up | < 35 V |
C2 Nominal discharge current (8/20) | In | 10 kA |
C2 Voltage protection level at In (line/G) | Up | < 60 V |
C2 Voltage protection level at In (line/line) | Up | < 40 V |
C3 Voltage protection level at 1 kV/μs (line/G) | Up | < 35 V |
C3 Voltage protection level at 1 kV/μs (line/line) | Up | < 35 V |
Bandwidth | B | 0 ÷ 1 MHz |
Lightning protection zone | LPZ1, LPZ2, LPZ3 | |
Housing material | Polyamid PA6, UL94 V-0 | |
Degree of protection | IP20 | |
Operating temperature | ϑ | - 40 ÷ 70 °C |
Recommended cross-section of connected conductors | S | 0.25 ÷ 1.5 mm2 |
Clamp fastening range (solid conductor) | 0.25 ÷ 4 mm2 | |
Clamp fastening range (stranded conductor) | 0.25 ÷ 2.5 mm2 | |
Tightening moment | 0,4 | |
Installation | On DIN rail 35 mm | |
Modular width | 1 | |
Operating position | Any | |
Signalling at the device | None | |
Remote signalling | No | |
Modular design | No | |
Lifetime | > 100 000 h |